Tower Omnibus F4 Pro Flight Controller Integrated OSD and SD Card Slot and PDB 2 in 1 Super Tower for RC Drone

Seems to work well, have to see how it holds up. The little ribbon cable was a pain, use a tiny flat blade screwdriver to press the ends in. Also, solder the ESC signal ground wires to the ESC power ground wires before you solder the ESC power grounds to the board. I wasn't sure where else to connect the signal grounds so that's how I did it. I initially had some difficulty getting the solder to stick to the pads for the ESC's but I attribute that to my novice soldering skills.

Solid boards, clearly marked, easy to solder up, very nice.

This fc is cheap as hell. Barely tapped signal wire after running on M2 and the pad lifted! After every other ESC was attached! Where’s my refund?!

Board is stuck in Blue LED mode. I emailed the seller and no response. Still not sure how to get it out of the blue programming mode. I'm using it on a 250 frame with Emax Bullet 35A ESCs -- ESCs are great -- board not so much...

I have two rigs with these stacks in it and have had zero problems. Not sure it supports F.Port but fine by me at this point. Looking at buying another one actually.

The signal pads for motor and 1 and 2 pulled off with very little force, luckily there is a also ports in the Flight controller that i can reroute the motor signal to

This board was good at first. Then out of the blue, it fell out of the sky. Now it wont even power on. Go figure it can't be returned after 30 days.

Pads rip off way too easy as well as the micro USB port and the black box feature wasn’t working on the unit I received.