⚡ Cut sharp, carve smart, and lead the creative charge!
The HQMaster CNC Router Bits 10-pack features 1/8" tungsten steel end mills with a spiral upcut design, delivering precise, fast, and burr-free cutting across a wide range of materials including wood, plastics, and composites. Engineered for durability and efficiency, these bits come in a convenient storage case, perfect for professionals seeking flawless 3D sculpting and milling performance.
B**L
My go-to bit for thin stuff
If you're doing production/rough passes, this is a very good bit. I run mine on a shapeoko 3 XXL, usually around 100ipm at 1/4" DOC in pine plywood at full RPM on the Dewalt 611.PROS: Quiet, no chatter until you get past the 12mm of tooth that they give you.Clean cutsOn the shapeoko 3, the bit will stall the motors before the bit breaks, so you arent constantly replacing bits.CONS: if you go past 1/2" material (i regularly cut 3/4"), it leaves behind a pack of powder on the last pass the Suckit dust boot can't pick up.In short, this bit is a personal favorite for high-speed cutting or production runs of blanks for art projects. In about 25 hours of cut time, i've wound up with 1 bit that has dulled beyond use. On my current rig, these cut faster and more reliably than any of the 1/4" bits without worrying about stalling or breaking. If you're going to be cutting relatively thin stuff, get this.
M**.
Just an FYI, .1240"
This is not bad or good, just an FYIOD = .1240" consistent across the set I receivedMy mic accurate to .000005
D**D
Flutes aren't very sharp
They'll work in a pinch but I wasn't impressed.
L**S
Cuts soft wood like knife thru butter
My first 1/8" end mill and I loved it. Cuts are clean, not much feathering, bit is sharp and precise. Chip outs on the picture happened because I used a very soft type of wood, most likely pine.
B**T
Great bits for the money
The perfect bits when you are just starting out.
Trustpilot
1 day ago
2 weeks ago