All Metal Hotend Kit for Creality CR-10 / CR10 / CR10S / Ender 2 / Ender 3 Ender 5 Printers .4mm

The Bowden Collet is junk and doesn't work with this hotend, you can spend the 9 bucks and buy one from Micro Swish or download one I created on Thingiverse ( Search - Meonxy .4mm All Metal Hotend Bowden Collet).Once it was fitted with that, worked as expected.

Recieved today and entire thing was useless. The clip that holds the Bowden tube in place is not doing its job. The tube just comes right back out. And being the fitting is built into the heat sink, I can't even replace with a new one. So it pretty much renders the whole assembly useless. Do not buy.

I've had issues with the other clone metal hotends, but this one has a titanium heat break that works. I'm able to print up to 260 degrees so far and haven't any problems with clogging up the heatbreak which happens on the other ones I've tried. I've had two of these now and I'm going to be getting two more so all my ender 3's will have these.I did follow the same instructions that are used for the Micro Swiss hot end if that is any help. I'll definitely keep getting them until they stop working :)

Clogs bad!!! Do not buy, waste of money! The the piece that goes into the hotend is to short to meet the extruder tip and leaves a open gap and cause instant clog.

Had to chase the threads to get the tube to install.Bowden tube retainer doesn't retain which makes it impossible to print.Completely useless, avoid at all costs.

Utter garbage clone. The bowden tube clamp is the worst I've ever seen. Do not buy. Repeat. Do not buy. This vendor shouldn't carry this garbage.

Seemed like a great upgrade...Boy was I wrong...The fitting-less design is worthless considering everytime I extrude it pushes the tube out and not the filament. COMPLETELY useless.

I wish I read the reviews first. They are accurate. Does not hold PTFE tube which renders it useless.